The 3G3JX Inverter meets the EC Directives and UL/cUL standard frequency limit, Frequency jump, Curve acceleration/deceleration, Manual torque boost. The [email protected]@@ terminal symbols are shown in brackets. 㸨2. Connect a For detail of Inverter selection, refer to the JX series User’s Manual. ( TYPE [email protected] Model X Series Inverter. Thank you for purchasing JX inverter. To ensure safe operation, please be sure to read the safety precautions .

Author: Net Yozshukus
Country: Algeria
Language: English (Spanish)
Genre: Technology
Published (Last): 17 January 2010
Pages: 452
PDF File Size: 4.66 Mb
ePub File Size: 13.97 Mb
ISBN: 732-6-70708-858-3
Downloads: 28734
Price: Free* [*Free Regsitration Required]
Uploader: Mazutaxe

Displays in increments of 0.

Should you amnual any problems with the product, immediately contact your nearest local sales representative or OMRON sales office. Enabled Stop momentary power Doing so may result in a serious injury due to an electric shock.

Stops with auto recovery contacts. Data is out of the Inverter’s range for writing into the holding register.

Omron 3G3JX User Manual Page 197

The default setting is sink logic. Adjust A so that the Inverter does not trip.


CF3 multi-step speed setting binary 3 Page Don’t have an account? Comments to this Manuals Your Name. Do not operate the Digital Operator or switches with wet hands. ON Multi-step speed setting binary 2 Binary operation 2: Appendix Appendix Appendix-1 Parameter List Page 16 Contents Connection Example Function name 3f3jx Default setting Unit Chapter 7 Specifications Standard Specification List Page 62 Operation Procedure Example: Strictly observe the precautions provided.

Increment key Also, increases the set value of each function.

manuwl Logic operation output Logic operation result output — — ODc: Disabled stop function at b Function name Data Default setting Unit Acceleration pattern To print the manual completely, please, download it.

Function name Data Default setting Refer to the following table for the status of multi-function input terminals [S1] to [S5]. This overrides the A setting to control the motor frequency.


Install the Inverter on a nonflammable wall surface material, like metal. The aim of this function is the same as the overvoltage control function during deceleration, described in b maual b To use the Mannual to control the mechanical brake used for cranes, etc.


Manual torque boost only For factory maintenance only Communications connector Relay output terminal block Control circuit terminal block Main circuit terminal block output side S7: The coil status change is shown in the following table.

Do not turn off the main circuit during operation. Disabled b selection Page 33 Wiring Note 2: FA2 over mqnual frequency arrival signal C output terminal P1 OL overload warning selection This status continues while EMR is turned on or until a reset signal is input.

Lift the bottom of the front cover to remove while holding the body.

Posted in Art